Cura Resume Print

Stop SD write M30.

Cura resume print. The total width of the lid was 3 mm and it printed 24 mm now only 06 mm part left to print. A drop-down menu is going to come up. Even though the M24 command is to resume SD card prints it usually does the job as M226 invokes M25 behind the scenes in most cases.

Enable or disable the Power-loss Recovery feature. Im guessing either I shouldnt move the printer head away from the print when changing filament or perhaps need to re-home after the new filament is in. So to avoid having to reprint the model from a scratch and replacing the tape and wait time to heat the bed and cry over wasted filament i decided to just resume the print from its last layer.

This can be used in two ways. The printer moved the XY back to the print and resumed. Anyhow since i returned to the office from the day before seeing the print halted and touching the bed and realizing it was hot freaked me out so I hit emergency stop on Repetier and accidentally quit it.

Open your Gcode with a text editor remove the start bit where it might prime or do. Delete SD file M31. Then it goes without any problem.

This is part 2 of a 3-part series. On that drop-down menu click on Post-processing. So now how can I resume this printing from where it left.

I just open the stl in 3d builder free cut the model in half save process in cura and print. In standard settings you dont have a chance to resume the print successfully. I am new to 3D printing and bought the best I could afford for my first printer Creality CR-10S Pro V2 from Tiny Machines.